Description
The Anycubic Axis Stepper Motors are official OEM high-precision 2-phase stepper motor replacements engineered specifically for the motion control gantry system of the Anycubic Kobra X and Kobra X Combo 3D printers.
Factory-matched to drive the high-speed motion channels of the Kobra X platform, these motors deliver reliable torque and exact micro-stepping accuracy under high acceleration. Equipped with pre-installed drive pulleys (for X/Y belt drives) or shaft couplings (for Z lead screws), each module provides a direct drop-in replacement to eliminate layer shifting, binding, or axis drift.
-
Y-Axis Motor (E18010164): High-torque chassis base motor driving the reciprocating heated bed bed assembly along the Y-axis.
-
Z-Axis Motor (E18010159): Vertical motion driver designed to connect with lead screws or vertical linear rails for precise gantry lift and Z-hop accuracy.
-
X-Axis Motor (E18010163): Mounts directly on the horizontal gantry beam to drive the printhead carriage back and forth during high-speed printing.
Features
Direct OEM Alignment: Factory wiring pinouts and exact mounting hole dimensions ensure drop-in replacement without soldering or rewiring.
Pre-Fitted Drive Hardware: Motors come with factory-installed timing belt pulleys or shaft couplers tailored for the Kobra X gantry.
High Torque & Low Heat Generation: Engineered with heat-resistant copper windings and low-resistance coils to maintain holding torque during multi-hour prints.
Fine Step Control: Standard 1.8 step angle provides accurate micro-stepping position retention to eliminate print surface banding and layer shifts.
Seamless Calibration Integration: Fully compatible with Anycubic Kobra X's Active Noise Cancellation, Auto-Leveling, and Resonance Compensation routines.
Specifications
Drive Interface:
Y-Axis Motor (E18010164) - Pre-Installed Belt Pulley
Z-Axis Motor (E18010159) - Precision Shaft Coupler
X-Axis Motor (E18010163) - Pre-Installed Belt Pulley
Printer Compatibility: Anycubic Kobra X Series
Motor Type: 2-Phase Hybrid Stepper
Step Angle: 1.8 (200 steps/rev)
Operating Voltage: 24V DC
Connector Type: 4-Pin JST Terminal Header
